language 

中国

韩国



NEWS

your current location:

Homepage

News

Industry Information

Introduction to the installation method of Cone pin with thread

Categories:Industry Information
Author:
Origin:
Time of issue:2022-07-06
Views:0

(Summary description)Cone pin with thread is a threaded fastener. People often ask about the installation methods of Cone pin with thread? Today we will introduce it.

Low price Cone pin with thread supplier(s) china

Discount Cone pin with thread from China manufacturer





Introduction to the installation method of Cone pin with thread

(Summary description)Cone pin with thread is a threaded fastener. People often ask about the installation methods of Cone pin with thread? Today we will introduce it.

Categories:Industry Information
Author:
Origin:
Time of issue:2022-07-06
Views:0

Information

Cone pin with thread is a threaded fastener. People often ask about the installation methods of Cone pin with thread? Today we will introduce it.

Cheap Cone pin with thread For sale
Cone pin with thread installation method:
1. Drill conical pin bottom holes in the middle of the two screw devices on both sides of the screw base with a hand electric drill, and spread them out diagonally.
2. Ream the tapered hole with the corresponding tapered reamer.
3. The manufacturer of Cone pin with thread tells you to maintain the stability of the reaming hole when reaming, and prevent the reamer from swinging and causing the flare and hole diameter to expand. When feeding, do not push the reamer hard, but press gently with both hands as the reamer rotates to make the reamer feed evenly.
4. Reverse rotation is not allowed when reaming or exiting the reamer, otherwise the hole wall will be roughened, or even the reamer will collapse.
5. When the reamer is stuck during manual reaming, do not move violently, take out the reamer in time, take out the chips, and continue to feed slowly after checking the reamer.
6. When reaming, test the hole diameter with a tapered cut. Cutting energy can freely penetrate 80% to 85% of the cutting length. The manufacturer of Cone pin with thread tells you that when the taper is pressed by hand, its head is 2-3mm higher than the surface of the workpiece, as shown in Figure 2, and then tapped with a copper hammer.
7. The manufacturer of Cone pin with thread tells you that after the taper cutting is hammered in, the large end of the chipper should generally be exposed or be as flat as the surface of the workpiece.

Keyword:

Scan the QR code to read on your phone

Previous: Cone pin with thread manufacturers take you to understand what the inner thread of the positioning pin does

Next: How to select Cone pin with thread

Previous: Cone pin with thread manufacturers take you to understand what the inner thread of the positioning pin does

Next: How to select Cone pin with thread